20
EN
10. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched o and unplugged the unit.
When unit is OFF and the tank of the dehumidier is full, the full indicator will be lit.
Additionally, when the unit is on and the tank is full, indicator will illuminate, and the unit
will automatically stop operating.
• Carefully remove the bucket. Slowly slide the water tank outwards to the accumulated
water does not overow.
• Lift the plastic lid, in order to remove the accumulated water from the tank, once the
water is emptied close the plastic lid once again, and place the tank securely and properly
into the device.
• When the water tank is re-installed the unit will automatically restart.
the tank.
Water automatically can be emptied into a oor drain by
attaching the unit with a water hose.
• Remove the rubber plug located opposite the unit.
Insert the water hose into the drain outlet and make sure
all connections are rmly tightened in order to avoid any
possible leaks.
• The dehumidier - air purier, should be placed on a at
surface in an upright position.
• Lead the water hose towards a suitable drainage facility
and be certain that the water ows naturally. For correct
drainage, make sure the hose stays below the level of the
drain hose outlet.
water drain
hose outlet
To Next Page
Loading...
Need help?
General
