9
EN
use.
Installation tips
1) Do not block or restrict the
airow around the unit. Make sure
the air inlet exhaust grills are not
obstructed. Allow 30cm of clearance
around the unit and 40cm above.
2) Place the unit in an area where
the temperature levels will not
fall bellow 5ºC (41ºF) There is a
possibility the coils will collect frost
at temperatures that are under
5ºC (41ºF), which may result in low
performance.
(Working conditions: 5°C-35°C,
30%RH–90%RH).
3) Ensure the lter is clean.
4) Place unit in vertical operating position and allow 2
hours before initial use in order to avoid malfunctions.
5) Before the initial operation, please check,
if the water level switch, located within the
water bucket area, is in the right position.
To Next Page
Loading...
