TROUBLESHOOTING TIPS
Before calling for service, review the chart below.
Problem
What to check
Unit does not start
Make sure the dehumidifier's plug is pushed completely into the
outlet.
Check the house fuse/circuit breaker box.
Dehumidifier has reached its preset level or bucket is full.
Water bucket is not in the proper position.
Dehumidifier does not
dry the air as it should
Did not allow enough time to remove the moisture.
Make sure there are no curtains, blinds or furniture blocking the
front or back of the dehumidifier.
The humidity control may not be set low enough.
Check that all doors, windows and other openings are securely
closed.
Room temperature is too low, below 5ºC(41ºF).
There is a kerosene heater or something giving off water vapor
in the room.
,
The unit makes a loud
noise when operating
The air filter is clogged.
The unit is tilted instead of upright as it should be.
The floor surface is not level.
Frost appears on the
coils
This is normal. The dehumidifier has an Auto defrost feature.
Water on floor
Hose to connector or hose connection may be loose.
Intended to use the bucket to collect the water, but the back
drain plug is removed.
ES, AS, P1 or P2 appear
in the display
These are error codes and protection codes. See the
CONTROL PADS ON THE DEHUMIDIFIER section.
Activate your warranty.....
in
5
simple
steps!
http://www.inventoraiconditioner.com
/warranty-inventor/
Select the product type
(airconditioner or appliance) for
which the warranty will be acivated
Choose the warranty that
corresponds to the product
in your possesion
Fill in the required information
(owner, retailer and appliance)
and press send
You will receive a confirmation
e-mail for the activation of
your warranty
For the electronic
warranty submission
please type the following link
http://www.
inventorairconditioner.com/
warranty-inventor/
Scan here for the
warranty form
Connect to the following link
To Next Page
Loading...
