• When unit is on, press the Timer button to activate the auto STOP function.
When the unit is o, press this button to activate the auto START function.
• Press the (+) or (-) button to change the time by 0.5 hour increments, up
to 10 hours or by 1 hour increments up to 24 hours. The control panel will
then count down time remaining until START or STOP.
• The time selected will be stored within 5 seconds and the main display will
automatically return to its previous state.
• When the auto START or auto STOP functions is set the Timer indicator is
lit identifying that ON or OFF timers are programmed.
• Turning the unit ON or OFF at any time or changing the timers setting to
0.0 will terminate the Auto Start/Stop function.
• When the control panel window displays code “P2”, the Auto Start/Stop
function will be terminated.
ION
Press the “ION” pad to switch on or o the ionizer. By activating the ionizer, negative ions
are released to purify the air and remove unpleasant and unhealthy particles. By pressing
once again this function will be terminated.
INDICATIONS
Indicator “FULL” turns red following a beep alert when bucket is full, removed, or misplaced.
• The water level control switch shuts o the dehumidier when the bucket
is full, removed or misplaced
When frost builds up on the evaporator coils, the compressor will cycle o and the fan will
continue to run until the frost disappears. In this case the display of the unit will show the
P1 code.
• This function not only ensures the safe and appropriate operation of the
dehumidier but is also more ecient and economical in its performance
NOTE:
To Next Page
Loading...
Need help?
General
