EasyManuals Logo

INVENTOR O1MVO-09 Service Manual

INVENTOR O1MVO-09
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
If any one of the following items is satisfied, the
defrosting will finish and the machine will turn to
normal heating mode.
----T3 rises to be higher than TCDE1.
----T3 keeps to be higher than TCDE2 for 80
seconds.
----The machine has run for 15 minutes in
defrosting mode.
7.4.3.5 Evaporator coil temperature
protection
T2
Resume
Off
Decrease
Hold
When evaporator temperature temp. is more
than the setting protection value, the
compressor will stop.
7.4.4 Auto-mode
This mode can be chosen with remote
controller and the setting temperature can be
changed between 17°C ~30°C
In auto mode, the machine will choose cooling,
heating or fan-only mode according to ΔT (ΔT
=T1-Ts).
T1-Ts
Cooling
Heating*
Fan only
Heating*: For cooling only models, they will run
at fan speed
Indoor fan will run at auto fan of the relevant
mode.
The louver operates same as in relevant mode.
If the machine switches mode between heating
and cooling, the compressor will keep stopping
for certain time and then choose mode
according to T1-Ts.
If the setting temperature is modified, the
machine will choose running function again.
7.4.5 Drying mode
Indoor fan speed is fixed at breeze and can’t be
changed. The louver angle is the same as in
cooling mode.
All protections are active and the same as that
in cooling mode.
7.4.6 Forced operation function
Forced cooling mode:
The compressor and outdoor fan keep running
and the indoor fan runs at low speed. After
running for 30 minutes, AC will turn to auto
mode with 24 setting temperature.
Forced auto mode:
The action of forced auto mode is the same as
normal auto mode with 24 setting
temperature.
When AC receives signals, such as switch on,
switch off, timer on, timer off, mode setting, fan
speed setting, sleeping mode setting, follow me
setting, it will quit the forced operation.
7.4.7 Timer function
7.4.7.1 Timing range is 24 hours.
7.4.7.2 Timer on. The machine will turn on
automatically when reaching the setting time.
7.4.7.3 Timer off. The machine will turn off
automatically when reaching the setting time.
7.4.7.4 Timer on/off. The machine will turn on
automatically when reaching the setting “on”
time, and then turn off automatically when
reaching the setting “off” time.
7.4.7.5 Timer off/on. The machine will turn off

Other manuals for INVENTOR O1MVO-09

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INVENTOR O1MVO-09 and is the answer not in the manual?

INVENTOR O1MVO-09 Specifications

General IconGeneral
BrandINVENTOR
ModelO1MVO-09
CategoryAir Conditioner
LanguageEnglish

Related product manuals