17
EN
When the room reaches the preferred humidity
level, there is a possibility of humidity appearance
on windows. This happens due to the temperature
dierence of the room’s and external ambient
temperature. Keep running the dehumidier and
when the air temperature outside increases the
windows should clear of condensation.
The desiccant dehumidier Rise Pro, operates with
an electrical resistance that warms up the desiccant
material. As a result, the temperature of the outgoing
air has been increased to 10°C comparing to the
room’s temperature. This doesn’t denote in any case
that this device can be used as a heating appliance.
The dehumidier has a separate FAN ONLY function, during which no
dehumidication takes place. Please check if you have selected this mode and try
to adjust the humidity levels. If the relevant button beeps without any change, then
try to turn o the FAN ONLY function following the steps from this user's manual.
l Make sure the dehumidier’s plug is placed completely into the socket.
l Check the house fuse/circuit breaker box.
l Check whether the power cord is damaged.
l Check the water bucket, if it is full, empty it.
l Check if the dehumidier has reached its preset level.
l Make sure the water bucket is positioned properly.
l Room temperature is lower or higher than the advised operational range.
l Check whether the humidity level has been set in high levels
l Make sure that the dehumidier has been operating enough time to remove the
moisture.
l Make sure there are no curtains, blinds or furniture blocking the front or back of the
dehumidier.
l The humidity selector may not be set low enough.
l Make sure you have cleaned the filter as suggested. Clogged filter may result in
reduced performance.
To Next Page
Loading...
