18
EN
l All house exits (windows doors etc) where the dehumidier is operating, should be
shut.
l Room temperature is below the advised operational range.
l There is a kerosene heater or something giving o water vapor in the room.
l The room that the device is placed is bigger than suggested.
l The humidity level is too high.
l The air lter is clogged.
l The device is titled instead of being in an upright position.
l The oor surface is not at.
l Check that the drain hose has been correctly placed.
l The drain hose has been blocked or damaged.
l C1: NTC1 is open cut or short cut
l C2: NTC 2 is open cut or short cut
l C3: NTC1 &NTC 2 are open cut or short cut
l C4: Sync motor failure
l 88: Temperature and humidity sensor failure
l P2: Water tank full
l P3: Pre-lter clean reminder
All the pictures in the manual are for explanatory purposes only. The actual shape of the unit
you purchased may be slightly dierent, but the operations and functions are the same.
The company may not be held responsible for any misprinted information. The design and
the specications of the product for reasons, such as product improvement, are subject to
change without any prior notice.
Please consult with the manufacturer at +30 211 300 3300 or with the Sales agency for
further details. Any future updates to the manual will be uploaded to the service website, and
it is advised to always check for the latest version.
Scan here to download the latest version of this manual.
www.inventorappliances.com/manuals
To Next Page
Loading...
Need help?
General
