To Next Page
B
bethanywardSep 7, 2025
What to do if inventum VWM9001B shows error E1?
- SStephen NicholsSep 7, 2025
If the inlet water is too cold, repeat the washing programme. If the washing machine reports this error again, call a service technician.
What to do if inventum VWM9001B shows error E1?
If the inlet water is too cold, repeat the washing programme. If the washing machine reports this error again, call a service technician.
What to do if the inventum VWM9001B Washer display unit and all buttons are unresponsive?
Manually stop the programme by pressing and holding the On/Off/Reset button for more than 3 seconds. Then, unplug the power cord from the outlet, plug it back in, and switch on the washing machine. If the error reoccurs, call a service technician.
What to do if inventum VWM9001B shows water drain system alert?
Check the following: • is the pump filter clean, • is the discharge hose clogged, • is the drain clogged, • if the discharge hose placed is placed below the maximum and above the minimum height.
What to do if inventum VWM9001B shows error E3?
Check if the water inlet valve is open, the filter on the water supply hose is clean, the water supply hose is not deformed, and the pressure in the water mains is between 0.05 and 0.8 MPa. Then, press the Start/Pause button to resume the programme. If the error reoccurs, call a service technician.
What to do if inventum VWM9001B shows error E7?
Check if the pump filter is clean, the discharge hose is not clogged, the drain is not clogged, and the discharge hose is placed below the maximum and above the minimum height. Then, press the Start/Pause button again. If the error reoccurs, call a service technician.
What to do if inventum VWM9001B shows error E2?
Make sure the washing machine door is closed. Unplug the power cord from the outlet, then plug it back in and switch on the washing machine. If the error reoccurs, call a service technician.
What to do if inventum VWM9001B shows error E5?
Restart the programme. If the error reoccurs, call a service technician.
What to do if inventum VWM9001B shows error E6?
Restart the programme. If the error reoccurs, call a service technician.
What to do if inventum Washer shows error E11?
If there is water in the drum that exceeds a certain level, and an error is reported, the washing program will be interrupted, and water will be pumped out. Restart the programme. If the error reoccurs, call a service technician. If the washing machine continues to add water, close the water tap and call a service technician.
What to do if inventum VWM9001B shows error E22?
Switch off the washing machine, switch it back on, and restart the washing programme. If the error reoccurs, call a service technician.
General| Type | Washing Machine |
|---|---|
| Load type | Front load |
| Capacity | 9 kg |
| Spin speed | 1400 RPM |
| Energy efficiency class | A+++ |
| Noise level spinning | 76 dB |
| Weight | 70 kg |
| Programs | Cotton, Synthetics, Delicates, Wool |
