What to do if the laundry is unevenly distributed in my Inventum Washer?
If you have smaller loads or clothes made of materials with special geometrical properties that are virtually impossible to distribute evenly across the Inventum Washer drum, manually distribute the laundry and run the spinning programme.
How to reduce noise and vibration in my Inventum Washer?
To reduce noise and vibration in your Inventum Washer, make sure the appliance is leveled using the adjustable legs and that the jam nuts are securely tightened.
What to do if my Inventum Washer shows error E3?
If your Inventum Washer displays error code E3, check the following: * Is the water inlet valve open? * Is the filter on the water supply hose clean? * Is the water supply hose deformed (clipped, clogged etc.)? * Is the pressure in the water mains between 0.05 and 0.8 MPa (0.5–8 bar)? Then, press the Start/Pause button to resume the programme. If the error reoccurs, call a service technician.
What to do if my Inventum Washer displays error E7?
If your Inventum Washer is showing error E7, check the following: * Is the pump filter clean? * Is the discharge hose clogged? * Is the drain clogged? * Is the discharge hose placed below the maximum and above the minimum height? Then, press the Start/Pause button again. If the error reoccurs, call a service technician.
What to do if the display unit of my Inventum Washer is unresponsive?
If the display unit and all buttons on your Inventum Washer are unresponsive, manually (physically) stop the programme by pressing the On/Off/Reset button and hold it for more than 3 seconds. Unplug the power cord from the outlet; then, plug the power cord back into the outlet and switch on the washing machine. If the error reoccurs, call a service technician.
What does error E11 mean on my Inventum Washer?
Error E11 on your Inventum Washer means the washing program will be interrupted and water will be pumped out of the washing machine due to excessive water in the drum. Restart the programme. If the error reoccurs, call a service technician. If there is water in the drum that exceeds a certain level, and an error is reported on the display unit, while the washing machine continues to add water, close the water tap and call a service technician.
How to resume washing program on my Inventum Washer?
To resume the washing programme on your Inventum Washer, press the Start/Pause button, or manually (physically) stop the programme and press the On/ Off/Reset button and hold it for more than 3 seconds.
What does 'PF' error mean on my Inventum Washer?
The washing process on your Inventum Washer was interrupted due to power supply failure. To restart, press the Start/Pause button.
Why does my Inventum Washer show error E1?
If your Inventum Washer shows error E1, it means the inlet water is too cold. Repeat the washing programme. If the washing machine reports this error again, call a service technician.
What does error E2 mean on Inventum Washer?
If your Inventum Washer displays error E2, make sure the washing machine door is closed. Unplug the power cord from the outlet; then, plug the power cord back into the outlet and switch on the washing machine. If the error reoccurs, call a service technician.
General| Capacity | 9 kg |
|---|---|
| Spin Speed | 1400 RPM |
| Energy Efficiency Class | A+++ |
| Color | White |
| Weight | 68 kg |
| Load type | Front load |
| Programs | Cotton, Synthetics, Delicate, Wool, Quick |
| Special features | Delay start, Child lock |
To Next Page
