What to do if my Inverter has over temperature protection?
If your Inverter is overheating, allow it to cool down. Enhance the ventilation surrounding it, relocate it to a cooler spot, and ensure the load aligns with the specifications.
What to do if Inverter has over temperature shut off due to bad ventilation?
If your Inverter shuts off due to high temperature caused by poor ventilation, switch it off and allow it to cool for 15 minutes. Clear any obstructions around the fan and the Inverter, move the Inverter to a cooler location, reduce the load as needed, and then restart it.
What to do if my Inverter shows a low voltage alarm?
If you're experiencing a low voltage alarm with your Inverter, try shortening the wire or using a wider cable. Also, ensure the battery is fully charged.
How to solve issue if AC appliances draw too much power from Inverter?
If AC appliances are drawing too much power from your Inverter, consider using a power inverter with a higher capacity.
What to do if the battery is over discharged and Inverter gives an alarm?
If the Inverter battery is over discharged and giving an alarm, replace the battery or use a battery charger to charge your battery.
How to fix poor connection of Inverter?
To address a poor connection in your Inverter setup, check all connections and tighten them securely.
What to do if Inverter has too large input current?
If the input current to your Inverter is too large, check the charging system's operation and ensure the battery's output voltage is within the correct range.
What to do if the current of the Inverter is too low?
If the current of your Inverter is too low, charge or replace the battery.
How to solve the problem of small range of reading of common ammeter for Inverter?
To get accurate data, measure the modified sine wave with a real effective value multimeter.
General safety warning about electrical shock from AC power.
Warning about hot surfaces and ventilation requirements for cooling.
Warning about flammable fumes and gases, advising against use in such environments.
Specifies requirements for safe and optimal inverter installation.
Provides instructions for connecting the inverter to a DC power source.
General| Output Waveform | Modified Sine Wave |
|---|---|
| Input Voltage | 12V DC / 24V DC / 48V DC (depending on the model) |
| Output Voltage | 110V AC / 220V AC (depending on the region) |
| Frequency | 50Hz / 60Hz (depending on the region) |
| Protection Features | Overload, Short Circuit |
| Efficiency | 85-90% |
To Next Page