Thicknesser
Model DGI-63D
02
13. USE RECOMMENDED ACCESSORIES.
The use of accessories and attachments not recommended by Delta may cause damage to the machine or injury to the
user.
14. USE THE PROPER EXTENSION CORD.
Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized cord will ca
use a drop in line voltage, resulting in
loss of power
and overheating. See the Extension Cord Chart for the correct size depending on the cord length and nameplate ampere
rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
15. SECURE THE WORKPIECE.
Use clamps or a vise to hold the workpiece when practical. Loss of control of a workpiece can cause injury.
16. FEED THE WORKPIECE AGAINST THE DIRECTION OF THE ROTATION OF THE BLADE, CUTTER, OR
ABRASIVE SURFACE.
Feeding it from the other direction will cause the workpiece to be thrown out at high speed.
17. DON’T FORCE THE WORKPIECE ON THE MACHINE.
Damage to the machine and/or injury may result.
18. DON’T OVERREACH.
Loss of balance can make you fall into a working machine, causing injury.
19. NEVER STAND ON THE MACHINE.
Injury could occur if the tool tips, or if you accidentally contact the cutting tool.
20. NEVER LEAVE THE MACHINE RUNNING UNATTENDED.
TURN THE POWER OFF.
Don’t leave the machine until it comes to a complete stop. A child or visitor could be injured.
21. TURN THE MACHINE “OFF”, AND DISCONNECT THE
MACHINE FROM THE POWER SOURCE before installing or re
m
oving accessorie
s
, before adjusting or chang
ing
set-ups, or when making repairs. An accidental start-up can cause injury.
22. MAKE YOUR WORKSHOP CHILDPROOF WITH PADLOCKS, MASTER SWITCHES, OR BY REMOVING
STARTER K
EYS.
The accidental start-up
23. STAY ALERT, WATCH WHAT YOU ARE DOING, AND USE COMMON SENSE. DO NOT USE THE MACHINE
WHEN YOU ARE TIRED O
R UNDER THE INFLUENCE OF DRUGS, ALCOHOL, OR MEDICATION.
A moment of inattention while operating power tools may result in injury.
24. USE OF THIS TOOL CAN GENERA
TE AND DISBURSE DUST OR OTHER AIRBORNE PARTICLES,
INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST AND ASBESTOS DUST.
Direct pa
rticles away from face and body. Always operate tool in well ventilated area and prov
ide for proper dust
removal. Use dust collection system wherever possible. Exposure to the dust may cause serious and permanent
respiratory or other injury, including silicosis (a seri
ous lung disease), cancer, and death. Avoid breathing the
dust, and avoid prolonged contact with dust. Allowing dust to get into your mouth or eyes, or lay on your skin
may promote absorption of harmful material. Always u
se properly fitting NIOSH/O
SHA approved respiratory
protection appropriate for the dust exposure, and wash exposed areas with soap and water.
To Next Page
Loading...