Troubleshooting
Status Messages
● Follow these steps until the error is clear.
1. press [7] and hold. and then connect to PC
2. press [1] and hold. and then connect to PC
3. Check Disk. ( for Windows)
4. pdate with the latest firmware
5. Reboot the PC
6. Change USB cable, and connect it to the back panel of PC
7. Connect to another pc
8. Connect to PC with pressing [9] and enter for 7 seconds.
wait for 2-3 minutes.
Please Wait ...
Disconnect ...
Saving data ...
Updating Flash ...
Input Limit...
Reconnect USB
Not Match...
NO DEVICE !!!
HDD ERROR !!!
HDD WARNING ???
please wait.
please disconnect.
please wait for saving data.
please wait for updating
Password error count exceeded.
please reconnect.
please reconnect.
Password is not matched.
HDD is not detected.
HDD Read Error.
or Too many bad sectors.
HDD have some bad Sectors.
To Next Page
Loading...