IOGear GCS1808i - Hotkey Functions; Hotkey Invocation and Commands

6
Hotkey Summary Table
The following table summarizes Hotkey operations on the GCS1808i /
GCS1816i:
Hotkey
All Hotkey operations begin by invoking Hotkey Mode. Invoking Hotkey
Mode takes three steps:
1. Hold down the Num Lock key
2. Press and release the minus key
3. Release the Num Lock key
[Num Lock] + [ - ]
Note:
1. The sequence uses the default hotkey invocation method. If you
selected the alternate hotkey invocation keys you would use [Ctrl]
and [F12] instead.
2. The Minus (or F12) key must be released within one half second,
otherwise Hotkey invocation is automatically cancelled.
[Num Lock] + [ - ]
or
[Ctrl] + [F12]
[A] [Enter]
Invokes Auto Scan mode. When Auto Scan
mode is in effect, [P] or left-click pauses auto-
scanning. When auto-scanning is paused,
pressing any key or another left-click resumes
auto-scanning.
[B]
Toggles the Beeper On / Off
[Esc] or [Spacebar]
Exits hotkey mode
[F1]
Set Operating System to Windows
®
[F2]
Set Operating System to Mac
[F3]
Set Operating System to Sun
[F5]
Performs a keyboard / mouse reset on the
target computer.
[H]
Toggles Hotkey invocation keys
[Port ID] [Enter]
Switches access to the computer that
corresponds to that Port ID
[R] [Enter]
Administrator only hotkey. It returns the
switch’s settings to their default values.
[T]
Toggles the OSD Hotkey between [Ctrl] [Ctrl]
and [Scroll Lock] [Scroll Lock]
[←]
Invokes Skip Mode and skips from the current
port to the first accessible port previous to it.
[→]
Invokes Skip Mode and skips from the current
port to the next accessible port
[↑]
Invokes Skip Mode and skips from the current
port to the last accessible port of the previous
Station.
[↓]
Invokes Skip Mode and skips from the current
port to the first accessible port of the next
Station.