IOGear GCS1934 - Page 15

Going Directly to a Port
Auto Scan Mode
15
GCS1932/1934’s Auto Scan feature allows you to monitor computer activities without
switching from port to port manually. This feature automatically cycles the KVM focus
through the computer ports at regular intervals. See table below for details.
Hotkey Function
[Scroll Lock] [Scroll Lock] [n][Enter] Brings the KVM, USB hub, and Audio focus to
computer attached to [n] port.
[n] stands for the computer’s Port ID number.
Replace [n] with the appropriate Port ID when
entering hotkey combinations.
Note: The KVM, USB hub, and Audio focus
all go to this port even if they were on di󰀨erent
ports to begin with.
[Scroll Lock][Scroll Lock][n][K][Enter] Brings only the KVM to the computer on [n] port
The USB hub and audio focus remain where
they are.
[Scroll Lock][Scroll Lock][n][U][Enter] Brings only the USB hub focus to the computer
on [n] port. The KVM and audio focus remain
where they are.
[Scroll Lock][Scroll Lock][n][S][Enter] Brings only the Audio to the computer on [n] port
The KVM and USB hub focus remain where
they are.
[Scroll Lock][Scroll Lock][n][K][U]
[Enter]
Brings the KVM and the USB hub focus to the
computer on [n] port. The audio focus remain
where it is.
[Scroll Lock][Scroll Lock][n][K][S]
[Enter]
Brings the KVM and Audio focus to the computer
on [n] port. The USB hub focus remain where it is.
[Scroll Lock][Scroll Lock][n][U][S]
[Enter]
Brings the USB hub and Audio focus to the
computer on [n] port. The KVM focus remain
where it is.
Hotkey Function
[Scroll Lock][Scroll Lock][A][Enter] Invokes Auto Scan
The KVM focus cycles from port to port at 5
seconds (default) intervals.
[Scroll Lock][Scroll Lock][A][n][Enter] The KVM focus cycles from port to port at [n]
second intervals.