20
PC Installation
Driver Installation Instructions for Windows NT
®
If your Zip
®
drive is connected to a new adapter card, you must install
driver software for the adapter on your Windows NT system. If the
necessary driver software is not installed, Windows NT may not
recognize your Zip drive.
This section describes how to install the necessary driver software for a
Zip Zoom SCSI card. If your Zip drive is connected to some other
adapter, refer to the documentation that came with the adapter or refer
to your Windows NT documentation for instructions on installing a
SCSI adapter.
M IMPORTANT! You must have administrator privileges for
your local computer in order to install software or drivers under
Windows NT. M
Installing a Zip
®
Zoom
™
SCSI Card under NT 4.0
1. If you have not already done so, install the Iomega software
package from the IomegaWare
™
CD using the Setup.exe program.
2. When the software installation is complete, the Iomega setup
program will prompt you to open the SCSI Adapters control
panel so that you can install the necessary driver software.
Click OK to proceed with the driver installation.
3. Select the Drivers tab and click the Add button.
4. Select Adaptec from the list of manufacturers.
5. Click on Adaptec AHA-152x/AHA-1510 SCSI Host Adapter.
6. Click Next to continue, then click OK for Windows NT to install
the necessary adapter driver on your system.
7. Click OK to exit. Note that you need to reboot your system for the
new driver to take effect.
To Previous Page
Loading...
