3. Ensure the filter is flush with the surrounding surface;
4. Flip the top cover forward and securely latch in place.
CLEANING THE UV LAMP (See Figure 5)
● To find the UV lamp:
1. Unplug the unit;
2. Press the release button and flip the top cover backward; (See Figure 5
and follow arrow ①)
3. Take out the filter from top cover by pressing and gripping the spring on
the filter cover; (See Figure 5 and follow arrow ②)
4. You should see the glass UV lamp; please handle the UV lamp with
extreme care;
● To clean the UV lamp:
Softly wipe the UV lamp with a dry, soft cloth to clean the dirt attached on
the surface of lamp;
CAUTION: The UV lamp is a glass product, please handle and clean it
carefully; Do not use a damp cloth or any liquid solution to clean the UV
lamp.
● To install the unit after cleaning the UV lamp:
1. Ensure the unit is unplugged;
2. Install the filter to the top cover as in the above INSTALLING THE
FILTER;
3. Ensure the filter is flush with the surrounding surface.
4. Flip the top cover forward and securely latch in place.
CLEANING AND MAINTENANCE OF THE UNIT
The air purifier should be cleaned at least once every three weeks. More
frequent cleaning may be required depending upon environmental
conditions.
1. Turn off and unplug the unit;
2. Press the release button and flip the top cover backward;
3. Remove and clean the collector rod as described in CLEANING THE
COLLECTOR ROD;
4. Turn the unit upside-down 2 or 3 times and hold for at least 3 seconds
each time. This allows the cleaning spheres inside the unit to scrape
To Next Page
Loading...