18. CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type. Batteries (a battery pack or an installed battery) shall
not be exposes to excessive heat such as sunshine, fire, etc.
19. Where the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
20. Protective earthing terminal: The apparatus should be connected to a
mains socket outlet with a protective earthing connection.
a. Finland (Suomi): Laite on liitettävä suojamaadoituskoskettimilla
varustettuun pistorasiaan.
b. Norway (Norge): Apparatet må tilkoples jordet stikkontakt.
c. Sweden (Sverige): Apparaten skall anslutas till jordat uttag.
21. This symbol means the equipment is a Class II or double-insulated electrical appliance. It
has been designed in such a way that it does not require a safety connection to electrical
earth.
22. Do not install this equipment in a confined or "boxed-in" space such as a bookcase or similar
unit, and maintain good ventilation conditions. The ventilation should not be impeded
by covering the ventilation openings with items such as newspaper, tablecloths, curtains, etc.
23. This apparatus is for professional use only.
24. When moving or not using the appliance, secure the power cord (e.g., wrap it with a cable
tie). Be careful not to damage the power cord. Before using it again, make sure the power
cord has not been damaged. If the power cord has been damaged at all, bring the unit and
cord to a qualified service technician for repair or replacement as specified by
the manufacturer.
25. WARNING: Excessive sound pressure (high volumes) from headphones can cause hearing
loss.
26. WARNING: Please refer to any important information (e.g., electrical, safety, etc.) printed on
the exterior bottom enclosure or rear panel before installing or operating the product.
SERVICE INS
T
RUCTIONS
•
Disconnect power cord before servicing.
•
Replace critical components only with factory parts or recommended equivalents.
•
For AC line powered units – Before returning repaired unit to user, use an ohmmeter to
measure from both AC plug blades to all exposed metal parts. The resistance should
be more than 2,000,000 ohms.
10
To Next Page
Loading...
Need help?
General
