Ficha técnica
Maximum pressure switch.
Solenoid valve for inlet control.
Solenoid flushing valve
Minimum pressure switch.
Electronic leak sensor.
Water quality control.
Maintenance warning.
414 x 130 x 445.
12,45.
3/8”.
1/4”.
1/4”.
3/8” M-F. *****
Tube Clamp
40 mm drainage.
TECHNICAL DATA SHEET
FOR REVERSE OSMOSIS EQUIPMENT
1. TECHNICAL FEATURES
APPLICATION
Water treatment
Reverse osmosis
Usage
Improvement of the characteristics of drinking water (complying with the requirements of the European Drinking
Water Directive 98/83 or its national transpositions in the different Member States of the European Community).
Modifications by reduction or contribution
- Reverse osmosis water treatment is able to reduce concentrations of salts and other substances by high percen-
tages.
- Minimum reduction* of certain compounds and parameters:
Sodium: 90%.
Calcium: 90%.
Sulphate: 90%.
Chloride: 90%.
Total hardness: 90%.
Conductivity: 90%.
* Depending on the characteristics of the water to be treated (at the exit of the membrane). These values may vary
depending on the type of post-filter incorporated in the equipment and/or regulation of the mixing valve (if included).
OPERATIONAL LIMITS
EQUIPO CON BOMBA
Pressure (max./min.):
TDS (max.):
Temperature (max./min.):
Hardness (max.):
4 bar - 1 bar (400kPa-100kPa).
1500ppm.
38 ºC - 5 ºC.
15 ºHF. **
Type of control:
Security system:
Dimensions (W x D x H in mm):
Weight (in kg, including all accessories):
Inlet connection:
Discharge connection:
Tap connection:
Wall adapter:
Drain collar:
A
B
C
1. Data interface
2. Drainage
3. Tap
4. Entrance
5. “Power”
1 2 3
4
5
To Next Page
Loading...