Ficha técnica
Normal.
There is little
left.
Exhausted.
> 15
0 < X ≤ 15
≤ 0
> 150
0 < Y ≤1 50
≤ 0
Permanent blue.
Permanent lilac.
Permanent red.
No alarm.
Double beep when filter
life is short.
Beeps when water is
dispensed.
When you detect that the unit is in one of
the states listed above, contact the main-
tenance service to make an appointment to
perform the required maintenance.
See the corresponding section in the tech-
nical manual.
Contact your technical service if the equip-
ment does not stop running (filling the tank)
after several hours of continuous operation,
without water extraction.
Contact your technical service if the equip-
ment is repeatedly blocked due to a lack of
mains water pressure at the inlet and there
is pressure in the rest of the dwelling.
Contact your technical service if after ope-
ning the faucet the equipment is at rest wi-
thout dispensing water through the faucet
or showing any type of alarm.
Contact your service technician to reset the
counters after changing filters.
3.3. IDENTIFICATION AND RECTIFICATION OF FAULTS
3.4. LIFETIME DISPLAY OF THE FILTERS
3.5. MANUAL WASHING MODE
Press the three buttons CF, RO and CB simultaneously for 3 seconds to activate the manual wash mode. After a
beep, the system washes the CF filter and RO membrane for 5 minutes. If during these 5 minutes the three buttons
are pressed again at the same time for 3 seconds or if the tap is opened, the system will automatically return to
normal mode.
Fault-light in red,
CF light in blue.
Fault-light in red,
uz RO in blue.
Fault-light in red,
CB light in blue.
Fault-light in red,
CF and RO light in blue.
Fault-light in red,
CB and RO light in
blue.
3 beeps.
Beeps for 3 mi-
nutes.
4 beeps.
5 beeps.
6 beeps.
When the water pressure at the inlet
returns, the system also returns to its
normal state, and the alarm is turned
off.
When the leak is repaired, the alarm is
deactivated and the system returns to
its normal state.
Since then the pump has been working
between 30 and 33 minutes. Discon-
nect and reconnect the electrical con-
nection.
Disconnect and reconnect the electri-
cal connection.
Disconnect and reconnect the electri-
cal connection.
1. Lack of water pres-
sure at the inlet.
2. Leakage inside the
machine.
3. Pump time pro-
tection.
4. Pump start/stop
protection.
5. Low temperature
protection.
TYPE
LIFESPAN LIFE REMAINING
(DAYS)
CAPACITY OF REMAI-
NING LITRES
NOTIFYER
DISPLAY ACOUSTICS
NOTIFYER
DISPLAY ACOUSTICS
SOLUTION
To Next Page
Loading...