21
3.2. FUNCIONALIDADES
During the wash, the water quality light
is shown flashing red at 1Hz. After 6 mi-
nutes, the water quality light will return
to the live measurement state.
When washing is in progress, the wa-
ter quality light shows the previous on
state.
When washing is in progress, the water
quality light shows the previous wash
status.
When washing is in progress, the water
quality light shows the previous wash
status.
When the RO membrane is being was-
hed, the water quality light is shown in
red and will flash at 1Hz.
When any other filter is washed, the
water quality light displays real-time
water quality data and flashes at 1Hz.
For the first 30 seconds, the water qua-
lity light shows the latest quality status
and is always on.
For the next 30 seconds, the water
quality light displays real-time quality
data and is always on.
The water quality light turns off.
After the power is turned on, a beep
sounds and all the lights turn on and off
at the same time, changing from blue to
lilac to red. Each color is displayed for
1 second.
The RO membrane will be washed by the
machine for 5 minutes. Afterwards, open the
tap for 30 minutes.
Whenever the system is turned on, it will
wash the RO membrane for 20 seconds. If
the user opens the tap, the machine will stop
washing and go into normal mode.
Each time the cumulative working time rea-
ches 2 hours, the system will wash the mem-
brane for 20 seconds. If the user opens the
tap, the machine will stop washing and go
into normal mode.
When the machine has been out of opera-
tion for 24 hours, the system will wash the
membrane for 20 seconds. If the user opens
the tap, the machine will stop washing and
go into normal mode.
CF: When changing the CF prefilter and res-
tarting its use counter, the system will start
a wash of the CF filter and RO membrane for
5 minutes.
RO: When changing the RO membrane and
resetting its usage counter, it must be was-
hed by opening the tap for 30 minutes.
CB: When changing the CB postfilter and re-
setting its use counter, the filter should be
washed by opening the tap for 15 minutes.
If all filters are changed and restarted at the
same time, the system will wash the CF fil-
ter and RO membrane for 5 minutes. Then
open the tap for 30 minutes to wash the CB
postfilter.
The system is put into normal operation.
The system stops producing water and is put
on standby.
The system starts.
1. Cleaning for first
use.
2. Cleaning when the
machine is switched
on.
3. Cleaning when run-
ning time is reached.
4. Daily cleaning.
5. Cleaning after
changing filters.
6. Opening of tap.
7. Closing the tap.
8. Switching on the
system.
FUNCTION ACTIONS LIGHT STAT US
To Next Page
Loading...