EasyManua.ls Logo

ionmax Ion632 - Troubleshooting

ionmax Ion632
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING
12
NOTE:
1. If the "CHECK" LED illuminates, turn off the unit, unplug from the power socket,
check and clean the filter. If it is dirty, remove any obstacle that covers the air inlet or
outlet, and wait for at least ten minutes before plugging in and switching back on.
2. Please contact your retailer if the problem continues.
Do not try to repair it yourself, as this could cause an electrical shock and void your
warranty.
Problem
Dehumidifier
doesnt start
(no lamp)
FULL lamp
lights
Water on floor
Water Less
CHECK lamp
lights
The unit is unplugged Make sure the plug is pushed completely
into the outlet.
The bucket is full or not in place
Empty the bucket, check the float in
position, and replace the bucket.
The unit falls down or is not level
on the floor / surface
Place the unit on a stable, level surface.
The air inlet or outlet is covered /
blocked
Filter clogged with dust
Make sure there is nothing blocking the air
inlet and air outlet of the unit. Clean the
filter. Unplug and wait at least 10 minutes to
resume operation.
The ambient temperature is too
high, such as over 40ºC
Do not use it in a small and closed place
where heat accumulates.
Move to a cooler place, wait at least 10
minutes to resume operation.
The unit is not level Check the unit is placed on a level
surface and not accidentally sitting on a
cable etc.
The drainage is clogged or loose Check the drainage hose and its
connectio
n.
The fuse is blown or circuit
breaker is tripped
Check the house fuse / circuit breaker box
and replace fuse or reset the breaker.
The room humidity has reached
the setting
It uis normal, you may choose Hi or Turbo
mode if you need a drier humidity level.
Possible Causes What to Do
The following conditions are normal:
1. The fan is still running about 2 minutes after turning off the the unit.
2. The unit works within room temperature about 1~40ºC. It may stop operation
out of this range or when the air inlet or outlet is covered. (The "CHECK" LED light
will illuminate)
3. The unit includes heater function that could increase the room temperature.
If your Dehumidifier stops working or "CHECK" LED illuminates, please check the following
items first.

Related product manuals