8
Hard Drive Installation (For Diskless Version Only)
This section shows how to install hard drives into a 216
Did you purchase your 216 preloaded with Hard Drives?
Skip to “Initial Setup of Disk Station Manager” on page 13.
Tools and Parts for Hard Drive Installation
Needed:
A Phillips screwdriver
3mm Hex Tool (included with the ioSafe 216
At least one 3.5” SATA hard drive
(Please visit http://iosafe.com/support-2baynas for compatible hard drive models.)
Note: For a RAID1 set, it is recommended that all installed drives be the same size to make the best use of hard disk
capacity.
Warning: If you install a hard drive that contains data, the 216 will format the hard drive and erase all data. If you need
the data in the future, please back it up before installation.
To Next Page
Loading...
