6
USING YOUR DEVICE FOR THE FIRST TIME
CHARGING THE DEVICE
You might need to charge the battery before using your
iOTA FLO.
1. Plug the power adapter into the DC-In socket;
2. Connect the power adapter to an electrical outlet and
charge the device until the battery is fully charged.
Note:
1. The battery is not fully charged when you unpack
your device;
2. A fully discharged battery takes about 5 hours to
fully charge;
3. When the battery is being charged, the LED indicator
light is red. When the battery has been fully charged,
the LED indicator will turn off.
TURNING ON THE DEVICE
Note: This iOTA FLO has been preinstalled with Windows.
You will need to perform an initial setup before the iOTA FLO
can be used.
1. Press and hold the Power button for 2 seconds to turn
your device on. The lock screen will appear;
2. The device is now ready for use.
Note: If the login screen is not enabled in Windows, you will be
taken directly from the lock screen to the start screen.
TURNING OFF THE DEVICE
You can turn off the device in two ways:
1. Press and hold the Power button for a minimum of 4
seconds;
2. Click on the shutdown confirmation screen to confirm
turning the device off.
CONNECT TO WI-FI
Turning On/Off Wi-Fi:
1. Select the Wi-Fi icon in the notification area, in the
lower-right corner of the screen to view the available
Wi-Fi hotspots;
2. Select available Wi-Fi icon to establish a connection.
Connecting to a network:
1. Select the Wi-Fi icon in the notification area, in the
lower-right corner of the screen, to view the available
Wi-Fi hotspots;
2. Select an available network from the list and select
Connect;
3. Input the password, if necessary, then select Connect
to begin an internet connection.
iOTA_FLO_UK_GER_FR_GUIDE.indd 6 14/06/2019 14:23
To Next Page
Loading...