IOXUS
18 Stadium Circle
Oneonta, NY 13820
Toll Free: +1 877-751-4222
sales@ioxus.com 2/17/2021
DOC 1-0004 Rev B
© 2021 Ioxus. All rights reserved.
Standby Mode is indicated by all LED’s being off while connected to battery power. uSTART
®
operation can
be confirmed by noting the change to a solid green LED upon engine start, indicating a return to Run
Mode.
Jump Start Charge Mode
uSTART
®
will automatically switch from Maintenance Mode to Jump Start Charge Mode if a vehicle’s
battery charging system is active for more than 10 seconds.
Jump Start Charge Mode also allows uSTART
®
to charge up its ultracapacitors from a weak vehicle battery
and provide power to jump start the vehicle.
Jump Start Charge Mode
can be
accessed through the uSTART
®
App. The green LED will be solid and the
yellow LED will flash as uSTART
®
charges its ultracapacitors. After the charging period finishes, the green
LED will be solid, indicating that the vehicle is ready to be started. Start the vehicle immediately for best
results. See the uSTART
®
App User Manual for additional details.
Fault Mode
uSTART
®
has experienced an abnormal condition or fault, indicated by a solid red LED. See the
Troubleshooting section for more information.
Bluetooth Connection
uSTART
®
is connected via Bluetooth when the blue LED is lit solid. See the uSTART
®
App User Manual for
more details (note that the blue LED may be difficult to see in bright locations, shading the status LED area
may help with seeing it).
Flow Charts
The below flow charts can be utilized for the most common scenarios of use: Installation, preparation for
service and use during a jump start attempt.
To Next Page