EasyManua.ls Logo

IPC CT 71 - Replacing the squeegee blades; Periodic Checks

IPC CT 71
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
Replacing the squeegee blades
Lower the squeegee.
Remove the suction hose from the squeegee
Lift the squeegee fastening levers.
Remove the squeegee from the slots on the support.
Open the hook (g. 20, ref. 1).
Push the two blade pressing devices (g. 20, ref. 2) outwards, then remove
them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the oor until all
four edges are worn out, or replace with a new blade, tting it onto the screws
on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the
slots on the squeegee body fastening pins, then push the blade pressing devic-
es inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Periodic checks
CHECKS DAILY OPERATIONS WEEKLY OPERATIONS
SIX MONTHLY
OPERATIONS
EMPTY AND WASH THE DIRTY WATER TANK X
CLEAN THE SQUEEGEE BLADES AND CHECK THEM FOR WEAR X
CHECK THAT THE SUCTION HOLE IN THE SQUEEGEE IS NOT BLOCKED X
RECHARGE THE BATTERIES X
CLEAN THE DIRTY WATER TANK FLOAT X
CLEAN THE SUCTION MOTOR AIR FILTER X
CLEAN THE WATER/DETERGENT TANK FILTER X
CLEAN THE SUCTION MOTOR HOSE X
CLEAN THE DIRTY WATER TANK AND THE SOLUTION TANK X
CHECK THE BATTERY ELECTROLYTE LEVEL X
HAVE THE ELECTRICAL CIRCUIT CHECKED BY QUALIFIED IP CLEANING PERSONNEL X
PERIODS OF INACTIVITY
If the machine is not used for some time, for example, on display in a showroom or stored in the warehouse for a period or more than one month, the
following operations are required:
Recharge completely the batteries. During long periods of inactivity, you should charge the batteries regularly (at least once every two
months) to keep them constantly at maximum charge.
Disconnect the batteries from the machine.
Unplug the battery charger (if present) from the mains power supply.
Remove the squeegee and brushes (or abrasive disks), wash them and put them away in a dry place (preferably in a bag or wrapped in
plastic lm) away from dust.
Make sure the tanks are completely empty and perfectly clean.
! WARNING
If the batteries are not recharged regularly as described above, they may be irrevocably damaged.
The manufacturer is not liable for any malfunctions resulting from neglect, improper and/or incorrect use.
! WARNING
When the batteries are at, make sure they are not left for an extended time without charging to avoid shortening battery life.
Check battery charge at least once a week.
1
2
20
20

Related product manuals