Page 46
with the electronic
battery charger, the
battery does not
provide the correct
voltage (about 2.14 V
per element without
load) and appears to
be uniformly not
charged when tested
with a hydrometer
(battery model only)
connected to the battery charger
(for example, because the low
voltage connector of the battery
charger has been erroneously
connected to the machine
connect the battery charger to the
battery connector
the battery charger and power
socket to which the battery is
connected are not compatible
check that the power supply
characteristics indicated on the battery
charger rating plate comply with those
of the mains power supply
the battery charger has not been
installed correctly
taking the actual voltage available at the
socket into account, make sure that the
connections of the primary of the
transformer inside the battery charger
are correct (consult the battery charger
the battery charger is not
working
make sure there is voltage to the battery
charger, that the fuses are not blown
and that the current reaches the battery;
try charging with another rectifier. If the
battery charger is not working, contact
the technical service centre and indicate
the serial number of the battery charger
At the end of charging with the electronic
battery charger, the battery does not provide
the correct voltage (about 2.14 V per element
without load) and only one or a few elements
are found to be discharged when tested with
a hydrometer (battery model only)
elements are
damaged
replace the damaged elements
if possible.
For 6 or 12 V single block
batteries, replace the entire
battery
in the battery is
turbid (battery
models only)
The battery has reached the end of the
charging/discharging cycles declared by the
the battery has been recharged with too high a current
the battery has been charged beyond the limit
suggested by the Manufacturer
To Next Page
Loading...
