IPC CT5 LAVAMATIC - User Manual

Questions and Answers

C
Christine WoodAug 13, 2025
Why is the squeegee on my IPC Floor Machine not cleaning well, or why is the vacuum weak?
- Y
  yjonesAug 13, 2025
  Several issues could cause the squeegee on your IPC Floor Machine to not clean well or the vacuum to be weak. The lip of the rubber blades in contact with the floor may be worn, in which case you should replace the squeegee blade. Also, the float-controlled shut-off may have been tripped because the dirty water tank is full, so empty the dirty water tank. Check for a blockage in the squeegee suction hose and remove any blockage. Ensure the suction hose is properly connected to the squeegee and repair it if damaged. Lastly, the diverter valve might be dirty, so clean the diverter valve.
G
Grant RuizAug 16, 2025
What to do if detergent solution is not reaching the brush on my IPC Floor Machine?
- A
  Ann ReillyAug 16, 2025
  If the detergent solution isn't reaching the brush on your IPC Floor Machine, it could be due to several reasons. The detergent tank might be empty, so fill the detergent tank. Alternatively, the water/detergent tank filter might be dirty, so clean the filter. Finally, there might be a blockage in the hose delivering detergent solution to the brush, so remove the blockage.
D
Daniel SmithAug 20, 2025
Why is the brush motor not starting easily on my IPC Floor Machine?
- P
  Penny LloydAug 20, 2025
  If the brush motor on your IPC Floor Machine isn't starting easily, it might be because the machine is working with a dry brush on a particularly rough floor. Try increasing the quantity of detergent.
K
Kim RamirezAug 25, 2025
What should I do if there is a brush motor thermal overload on my IPC Floor Machine?
- N
  Nicholas ChavezAug 25, 2025
  Switch off all functions of the machine. Remove the dirty water tank to let more air into the motor housing. Wait a few minutes, then restart the machine. If the problem persists, contact customer service.
K
Kristin JosephAug 28, 2025
What should I do if there is a brush motor overcurrent or short circuit on my IPC Floor Machine?
- M
  Mrs. Jamie MasonAug 28, 2025
  Switch off all functions of the machine. Restart the machine. If the alarm appears again, make certain that the brush is not being used on a particularly rough floor. If the problem persists, contact customer service.
D
davidbarberAug 31, 2025
What should I do if there is a detergent pump overcurrent or short circuit on my IPC Floor Machine?
- H
  hwebsterAug 31, 2025
  Switch off all functions of the machine. Restart the machine. If the problem persists, contact customer service.
J
Jennifer NewmanSep 4, 2025
What should I do if the suction motor has an overcurrent or short circuit in my IPC Floor Machine?
- J
  Jeffrey MasonSep 4, 2025
  Switch off all functions of the machine. Restart the machine. If the problem persists, contact customer service.
M
Mr. Franklin ButlerSep 7, 2025
What to do if there is excess battery voltage in my IPC Floor Machine?
- A
  Amber WattsSep 7, 2025
  Check the integrity, operation and use of the battery charger supplied with the machine.