IPC Plus D 1915P - Pag. Use

English
- 23 -
- Water cleaners with the
"Total Stop” device should
be considered as o󰀨 when
the omnipolar switch is in
the “O” position or the plug
is unplugged from the sock-
et.
- When the water cleaner is not
used, close the safety device
onthehandle.(g.10)
- Dry use of the water cleaner
causes serious damage to
pump gaskets.
FIG. 10
USING THE ACCESSORIES.
Thehighpressurewasherhasanozzlewithaatanglejetfor
cleaning large surfaces.
Warning
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
ROTARY HEAD (optional accessory)
Thehighpressurewashercanbettedwithaheadwithrotary
nozzle to clean the most stubborn dirt.
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
Do not aim the jet at people, animals or electrical sockets.
STOPPING THE CLEANER
1)Switcho󰀨the burnerbyturning thepressure regulatorto
pos."0"(g.8B).
2) Let the cleaner run with cold water only for at least 30 seconds
to cool down the boiler.
3) Stop the cleaner by turning the selector switch to pos. "0"
(g.8A).
4) Discharge the pressure from the H.P. hose by pressing the
trigger on the gun.
5) Disconnect the water cleaner from the mains electricity
supply via the omnipolar switch or by unplugging the plug from
the socket.
6)Turno󰀨thewatersupplytap(g.6A).
Warning
-Ifthewatercleanerisleft,eventemporarily,turnito󰀨byusing
the omnipolar switch or by unplugging the plug from the socket.
FIG. 8
FIG. 9
USING
THE CLEANER
CONTROL PANEL
A-On/o󰀨switch
B - Temperature regulator
C - Detergent control tap (if
available).
D - Pressure gauge.
STARTING THE CLEANER
1)Turnonthewatersupplytap(g.6A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1
(g.8A).
Warning
The high pressure water jet generates a reaction force in the
lance.Keeparmgriponthelancehandle.
4) Press the trigger on the gun and begin washing.
5) To use the cleaner with hot water, turn the temperature regu-
lator(g.8B)totherecommendedwashingvalues.
Forsome modelsturn theignition switch(g.8A) onto the
hot water positionbefore e󰀨ecting the operations described
in this point.
Warning
In water cleaners with the “Total Stop” system, the motor starts
and stops when the lever on the lance handle is actioned or
released.
Danger
Do not block the handle lever in the delivery position.
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the rst time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfun-
ction (g. 9).
!
!
!
!
!
!
A
B
C D