iPECS ES-3052G - Page 104

C HAPTER 4 | Basic Management Tasks
Managing System Files
– 104 –
ES-3052 Series
If you replaced a file currently used for startup and want to start using the
new file, reboot the system via the System > Reset menu.
SETTING THE START-
U
P FILE
Use the System > File (Set Start-Up) page to specify the firmware or
configuration file to use for system initialization.
CLI REFERENCES
◆ "whichboot" on page 552
◆ "boot system" on page 547
WEB INTERFACE
To set a file to use for system initialization:
1. Click System, then File.
2. Select Set Start-Up from the Action list.
3. Mark the operation code or configuration file to be used at startup
4. Then click Apply.
Figure 10: Setting Start-Up Files
To start using the new firmware or configuration settings, reboot the
system via the System > Reset menu.
SHOWING SYSTEM
FILES
Use the System > File (Show) page to show the files in the system
directory, or to delete a file.
N OTE : Files designated for start-up, and the Factory_Default_Config.cfg
file, cannot be deleted.
CLI REFERENCES
◆ "dir" on page 551
◆ "delete" on page 551