20
STARTING YOUR GENERATOR
1. Make sure all appliances are
disconnected from the generator.
2. Move engine choke lever to the
“START” position.
3. For recoil sWDUW¿UPO\Jrasp the recoil
handle and pull slowly until increased
resistance is felt. Pull rapidly up and
away.
4. When engine starts, move choke
lever to 1/2-CHOKE position until
engine runs smoothly and then
fully into “RUN” position. If engine
falters, move choke back out to
1/2-CHOKE position until engine
runs smoothly and then fully into
“ON” position.
Recoil Start
CAUTION
When starting the engine with the recoil start, set the toggle
switch in the “ON” position before pulling the starter handle.
NOTICE
,IHQJLQH¿res, but does not continue to run, move choke
lever to the “START” position and repeat starting instructions.
NOTICE
If engine fails to start after 3 pulls, or if unit shuts down during
operation, make sure unit is on a level surface and check for
proper oil level in crankcase. This unit may be equipped with a
low oil protection device. If so, oil must be checked at proper
level for engine to start and run.
START RUN
CHOKE LEVER
To Next Page
Loading...
