134 135
Steps for cleaning:
1. Turn o the diuser and unplug from the power source.
2. Remove the top and inner covers.
3. Empty any water left in the unit by pouring the water out from the back of the unit. Avoid water flowing across the air outlet.
4. Use a clean, damp, soft cloth to clean the unit to remove all traces of fragrance or oil built up in the water tank. Do not use corrosive or abra-
sive cleaners or chemicals. If the mist plate is clogged, gently and carefully rub the ceramic disc with a cotton bud, making sure not to scratch
it. If required to remove heavy oil residue, add a few drops of isopropyl or white vinegar mixed with water. Pour the mix into the water tank
and wipe with a clean cloth. Once this step is finished, empty the mix out, avoiding the air outlet. Rinse with clear water and let it dry.
Now your diuser is clean and ready for use.
TROUBLESHOOTING
Status Possible cause(s) Solution(s)
Start-up Failure/Early shutdown Insucient water Add less than 150 ml water, or not above the water mark
(Max).
Improper power wire connection Unplug the power adapter plug and reset carefully
Failure or abnormality of misting
but light is working
No water or water too less Add less than 150 ml water
The water exceeds the max level line Empty the excess of water carefully to the max level line
The mist plate is clogged (dust, oil
residues...)
Refer to maintenance part for cleaning the mist plate
Water leakage Top cover or inner cover are
o-centered of missing
Adjust the top cover and inner cover to make sure they are
properly aligned
High humidity/temperature too low
or too high
Adjust the room temperature of humidity
The remote is not responding The insulation sheet is still on (first
use only)
Gently pull on the plastic strip located at the bottom of the
remote to slide o the battery insulation sheet.
The battery has no power Change to a new battery
RECYCLING AND DISPOSAL
Do not dispose this product with ordinary household waste at the end of its life. Please take it to a collection point for recycling elect-
rical and electronic equipment. Instructions as to the correct method of disposal are provided by the symbol on the product, in the
instruction manual, or on the packaging. The materials are recyclable as indicated by the symbols. By recycling materials or reusing old
appliances in other ways, you are making an important contribution to protecting the environment. Please ask your local council for
the location of authorised disposal points.
MAX
1.
4. 5. 6. 7.
2. 3.
MAX MAX
MAX
MAXMAX
MAX
MAX
MAX
MAX
MAX
MAX
Air outlet
Empty the water in the opposite way to the air outlet. Do not
empty the water in the air outlet, this would damage the diuser.