IQAir HealthPro series Getting Started

Getting Started with Your IQAir
®
HealthPro
®
Series
Thank you for choosing IQAir for your air cleaning needs. These instructions will assist you in getting started with
your IQAir system in a matter of minutes. Simply follow the instructions below. To access some of the more advanced
features of your IQAir system, such as the timer, please refer to the user manual. We recommend that you familiarize
yourself with the safety instructions in the user manual before rst use.
Your IQAir system is supplied with the following items:
• User manual
• Certicateofperformance(individuallynumberedandhand-signed)
• Technicalsupportandwarrantyregistrationcard
• IQAirreferralprogramcard
• Powercord
• Remotecontrol(incl.battery)
• Setof4casters
Setting Up Your IQAir System
1
A) Unpacking
TounpackyourIQAirsystem,openthetopoftheboxandremovethetopfoampiece.Laytheboxonitssideand
pulltheaircleaneroutbyitstophandle.Placethesysteminitsuprightpositionandremoveallpackagingmaterials.
Toprovidea“plug-and-play”experience,thesystemhasshippedwithalllterspre-installed.Duringshippingitis
possiblethatsomedustfromthecarbonltermayhavebecomeloose.Thiscanbecleanedwithadampcloth.
B) Installing the casters
Installingthecastersisnotnecessarytooperatethesystem;however,itmayfacilitatemovingtheaircleanerfrom
roomtoroom.Pleaserefertotheusermanualforcasterttingandremovinginstructions.
C) Choosing a suitable location
YourIQAirsystemshouldbeplacedintheroomwhereaircleaningisneeded.Itshouldbelocatedideallyonefoot
(30cm)awayfromthenearestverticalsurfacetoallowformaximumaircirculation.
D) Connecting to the power supply
Plugtheconnector-endofthepowercordintothebaseofthesystem.Locateasuitablewallsocketandconnect
thepowercord.YourIQAirsystemisnowinstandbymode,readytobeswitchedon.
Visit www.iqair.com/startforvideoinstructionsonhowtosetupyourIQAirsystem.
A) Switching your IQAir system on and o
Toswitchthesystemonoro,simplypressthePOWERbutton,locatedonthefarleftofthecontrolpanel.
Thesystemisintendedtoruncontinuouslywhenusersarepresent.Operatingthesystem24hoursperday
willnotharmthesystem.
B) Regulating the fan speed
Toselectthedesiredfanspeed,simplypresstheARROWbuttononthecontrolpanel.Whenthetopspeed
hasbeenreached,thedisplaywillstartagainatthelowestfanspeed.
Using the Electronic Control Panel
2
(over)

IQAir HealthPro series Specifications

General

Fan Stages	6
Warranty	5 years
Model	HealthPro series
Pre-Filter	Yes (typically a washable pre-filter for coarse dust and allergens)
Gas & Odor Filter	V5-Cell (activated carbon and alumina)
Coverage Area	Up to 1125 sq. ft.
Airflow	300 CFM
Particle Filtration	99.97% at 0.3 microns
Gas & Odor Filtration	Yes (V5-Cell filter)
CADR	300 (smoke), 300 (dust), 300 (pollen)
Filter Life	HyperHEPA: 4 years, V5-Cell: 2 years
HEPA Filter	Yes (HyperHEPA filter for particles down to 0.003 microns)