What to do if the IR Energy EvenTube ETS burner does not stay lit?
If the burner does not stay lit, check the ground wire continuity and the insulation on the igniter leads. Measure the flame signal current; it should be between 2 to 6 micro amps dc, with a minimum of 0.8 micro amps. If needed, clean the flame rod or replace the module.
What to do if the IR Energy EvenTube ETS Heater burner does not light?
If the burner does not light, check if a spark is visible through the site glass during ignition. If not, further electrical checks by a qualified service person are required. Also, check to see if gas lines were properly purged of air. Check inlet and outlet gas pressure during ignition and verify proper orifice and air plate.
Why is there no gas supply to my IR Energy Heater?
If there's no gas supply, first check if the manual supply valve to the heater is ON, and then check if the gas valve knob on the heater gas control is also ON. You can check the supply gas pressure at the 1/8" NPT pressure tap in the gas supply system. Also, if gas pressure downstream of gas control can be measured, no manifold pressure indicates valve is closed. If the valve is closed, either the gas valve or the ignition module is faulty.
How to fix an IR Energy Heater blower motor that fails to run?
First, ensure the heater is plugged in and that there is 115V at the burner receptacle. Next, check the blower for any obstructions. If there are no obstructions and the blower still doesn't run, it may need to be replaced.
Key safety warnings, precautions, and essential requirements for safe heater operation and placement.
Adherence to national and local codes for gas supply, electrical grounding, and installation procedures.
Detailed list and illustrations of components for the ETS 50 model.
Detailed list and illustrations of components for ETS 60, 80, and 100 models.
Diagrams showing physical dimensions and measurements for the ETS 50 model.
Diagrams showing physical dimensions and measurements for ETS 60, 80, and 100 models.
Details on gas supply, inlet pressure, manifold pressure, and electrical supply requirements.
Minimum clearances required between the heater and combustible materials for safe installation.
Guidelines for heater mounting, height, and information regarding its outdoor-only, no-venting design.
Ensuring installation adheres to local building codes and national fuel gas and electrical codes.
General guidance on the recommended installation sequence for free-hanging setups.
Step-by-step instructions for assembling and installing the ETS 60, 80, and 100 models.
Step-by-step instructions for assembling and installing the ETS 50 model.
Information on electrical grounding, wiring standards, and general wiring diagram for the ETS heater.
Diagrams and notes for connecting manual line switches and two-stage switches.
Detailed steps for safely lighting the infrared heater, including ignition sequence and safety checks.
Instructions for turning off the heater for short or extended periods of inactivity.
Recommended maintenance tasks to be performed before each heating season for optimal performance.
Guidance for diagnosing and resolving common problems like blower failure and lack of gas supply.
Diagnosing issues related to the burner failing to ignite or stay lit, checking spark and flame signals.
Flowchart for systematically diagnosing and resolving heater operational problems based on symptoms.
To Next Page
General