IRIS ID IrisAccess iCAM7000 Series

To Next Page

iCAM7000 SERIES

HARDWARE GUIDE

ADVANCED MULTIFACTOR BIOMETRIC IRIS READER

Fully automatic dual iris capture

Simple non-intrusive, non-contact user interface

Integrated megapixel face camera with flash

ISO/ANSI compliant iris and face images

Integrated contactless smart card reader [optional]

Surface mount plate included; Recess mounting kit [optional]

VERSION 1.1

Packing List

Required Equipment (not included)

Power Source

12-24 VDC +/- 10% / Minimum 24W (12VDC @ 2AMPS)

(Measured at iCAM unit)

Uninterruptable Power Supply (strongly recommended)

Network

Ethernet Wiring CAT5e Ethernet Cabling (or better)

Ethernet Switch

Software

Required Software for desired system type

(IrisAccess EAC, iData SDK, etc.)

What’s in the Box

iCAM7000 series

Hardware Guide

L wrench

iCAM7000 series Hardware Guide

ISO/ANSI

COMPLIANT

CONTACTLESS

CARD READER

FACE

CAMERA

DUAL

IRIS

EASY

INSTALLATION

L wrench

iCAM7000

iCAM7010

Main Page

Need help?

Do you have a question about the IRIS ID IrisAccess iCAM7000 Series and is the answer not in the manual?

Summary

Installation Guidelines

Recommended Mounting Information

Specifies optimal height and environmental considerations for unit placement.

General Wiring Requirements

Outlines the necessary network and power wiring specifications for setup.

iCAM Installation

Surface Mounting

Step-by-step instructions for attaching the unit to a surface.

Gang Box Mount

iCAM Configuration

Accessing the iCAM Configuration Interface

Guide on how to connect to and use the unit's web-based configuration tool.

How to Operate

Tilt Adjustment and Capture Range

Restoring The Unit to Factory Default

Factory Default Button Usage

Instructions on using the physical button to reset IP or all settings.

Fuse Replacement

How to Replace the Fuse

Step-by-step guide for replacing the unit's internal fuse.