12
●
Conduct maintenance after stopping
the operation and removing the plug
from the electrical power socket.
●
Do not wet the machine's body.
Failure could cause an electric shock,
injury, or machine malfunction.
●
Do not use detergent, thinner, benzene, bleach, etc.
●
Do not use a chemical impregnated cloth to
clean the machine.
Body
When dirty;
•
Squeeze a cloth which has been soaked in water
or warm water (below 40
o
C degrees Celsius)
and wipe away any dirt.
•
If it is difficult to wipe away any dirt, wipe with
soft cloth soaked in a diluted kitchen detergent.
Then, wipe with using a tightly squeezed cloth to
remove the detergent.
Hand tool, collecting tank, vacuum hose
After using every time;
•
Remove these accessories from the body and
clean with water, then dry thoroughly.
Collecting tank Hand tool
Vacuum hose
Maintenance
•
Clean the hand tool with water after removing
the transparent cover to the inlet port.
<How to remove the transparent cover>
Lift this part
to unlock
<How to install the transparent cover>
①
Hook the cover by putting holes at claw
Hand tool
Claw
Holes
Transparent
cover
②
Install it by inserting until clicking into place
Click
•
If you nd something stuck in the nozzle, remove
it by cleaning the nozzle.
Nozzle
To Next Page
Loading...