1. CONTENT
1. OMM Contents
2. General
3. Boiler application
4. Fuel
5. Description of the
- PLUS
boiler
6. Technical and operating parameters
7. Boiler installation
8. Connecting the boiler to the chimney
9. Connecting the boiler to the heating system
10. Filling the boiler with water
11. Lighting the boiler
12. Refueling the boiler
13. Boiler cleaning
14. Shutting the boiler down
15. Boiler maintenance and repairs
16. Boiler transportation
17. User obligations
18. Final remarks
19. Delivery specification
20. Boiler diagram
21. Declaration of conformity
22. Warranty card and acceptance inspection report
23. Practical advice to the user
24. Sample of central heating installation diagram
25. The regulation of the boilers door
2. GENERAL
Please read this Operation and Maintenance Manual to be able to use the boiler
properly and safely. Because this manual covers several boiler sizes before you continue
reading it, please read the boiler name plate to determine the boiler size and be able to use
this manual properly.
Before you connect the flue duct to the chimney you should get an approval
from an authorized chimney service pertaining the suitability of the specific chimney
duct you intend to use.
The
- PLUS
boiler is the only boiler available on the market with a shifted
convection chamber, i.e. the boiler part that receives heat from flue gas, which significantly
improves the combustion conditions and minimizes the amount of dust exhausted through
the flue into the atmosphere.
3. BOILER APPLICATION
The steel boilers of the
- PLUS
type are intended for ncentral heating
systems in residential houses, shopping centers, garages, commercial premises, office
buildings, service outlets, catering premises, etc.
The boiler water temperature must not exceed 100°C.
The boiler should be assembled by an authorized company or specialist, who is also
to provide boiler security features.
The
- PLUS
boilers can be used in with both gravity and pumped heating systems.
Thermal balance of heated rooms prepared based on valid national standard is a base to
match a proper boiler to the central heating installation.
The rated boiler calorific effect should be equal or slightly higher (up to 10%) than the
calculated water demand of the rooms heated.
To Next Page
Loading...
General