Power supply wiring
After inserting the pins into
the car power connector, use
the provided tape strips to hold
the wires in place. This will
prevent the wires from
separating.
®
Be sure that the pins on the wires from the IRO Dashcam are fully inserted and making good
contact before applying the tape. Once the wires are properly connected, you will hear an
®
audible beep from the IRO Dashcam. You will also see the green light indicating the unit is
powered on. If this doesn’t happen, check your wiring to make sure the pins have good contact
with the car power connector and the wires are not loose.
05
To Next Page
Loading...