IRO Dashcam A66 - Power Supply Wiring

Power supply wiring
Insert the pin on the
end of the red wire
from the camera to
the red/yellow wire of
the car power connector.
Insert the pin on the
end of the black wire
from the camera to
the black wire of the
car power connector.
®
The IRO Dashcam is powered from the car ’s rearview mirror. This avoids having to run
®
power wire throughout the car and into the fuse panel. This method of powering the IRO
Dashcam is more streamline, and avoids having to see ugly wires. The TF card is inserted last.
04