iRobot Roomba Combo j7+ - Robot Maintenance: Sensors, Bin Sensors, and Brushes; Cleaning Visual Docking Target and Charging Contacts; Cleaning Full Bin Sensors; Cleaning the Multi-Surface Brushes

Roomba Combo® j7+ Owner’s Guide 8
EN
Pinch the Brush
Frame Release
Tab, lift the Tab
and remove any
obstructions.
Remove the Brushes from the robot. Remove
the Brush Caps from the ends of the Brushes.
Remove any hair or debris that has collected
beneath the Caps. Reinstall the Brush Caps.
Cleaning the Multi-Surface Brushes
1
2
Cleaning the Full Bin Sensors
Wipe the inner
Sensors with a
clean, drycloth
Wipe the Bin Door with a clean, dry cloth.
2
3
Remove and empty the Bin.
1
Closed door
Opened door
Clear any
debris from the
vacuum path.
4
Remove any hair or debris from the square
and hexagonal pegs on the opposite side
of the Brushes.
Reinstall the Brushes in the robot. Match the
shape of the Brush pegs with the shape of the
Brush icons in the Cleaning Head module.
3
4
Cleaning the Visual Docking
Target and Charging Contacts
Inspect the Visual Docking Target
and Charging Contacts to make
sure that they are clear of debris.
Wipe with a clean, dry cloth.
1
Note: Do not spray cleaning
solution directly onto Sensors
orinto Sensor openings.