iRobot RVC-Y1 - Cleaning Full Bin Sensors; Cleaning the Edge-Sweeping Brush; Cleaning the Front Castor Wheel

Roomba
®
e6 Owner’s Guide 5
EN
Washing the Bin
Cleaning the Full Bin Sensors
Wipe the inner sensors with a clean,
dry cloth.
Make sure that the bin is completely dry.
Reinsert the filter and place the bin back
into the robot.
2
3
Important: Do not wash the filter.
Remove the filter before washing the bin.
Release the bin, remove the filter,
and open the bin door.
Remove and empty the bin.
1
1
Note: The
bin is not
dishwasher
safe.
Use a coin or small screwdriver to
remove the screw holding the Edge-
Sweeping Brush in place.
Remove the Edge-Sweeping Brush,
clean the brush and the brush post, and
then reinstall the brush.
Cleaning the Edge-Sweeping Brush
1
2
Cleaning the Front Castor Wheel
Pull firmly on the front wheel to remove it.
Remove any debris from inside the
wheelcavity.
Reinstall all parts when finished. Make
sure the wheel clicks back into place.
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
1
2
3
Wheel
Axle
Housing
Rinse the bin using
warm water.
2