isel automation CPM 2018 - Page 16

16
isel-CNC Compact Equipment CPM
 STOP
Execution of the current program is immediately stopped and remains at the (program)
location. The tooling machine is switched off. In the DNC mode, you can issue further
commands via software. This is not possible in the CNC mode.
After a time delay of 1 or 5 seconds, the COVER button lights up and you can open the
hood. With a closed hood, you can continue the program by pressing the START button.
 COVER
Only if the button is lit, you can open the hood by pressing this button (first, press the
button, then pull simultaneously at the grip!). In the unfavorable case if you set only a
delay period of one second, the spindle can continue to rotate for a few seconds.
Do not reach into the still revolving tool.