6
isel-CNC Compact Equipment CPM
2 Notes on safety
- The machine must not be operated in a blast capable atmosphere.
- The machine is completely encapsulated. The casing protects you against moving tools,
decreases the operating noise level, and restrains the chips.
- While tooling, the hood is locked and can not be opened.
You may neither remove nor modify this protection measure (only type 2 and 3).
- Hardware and software are included in the safety circuit i.e. the machine functions only with
the appropriate and intact controller heart on the printed circuit board
(only type 2 and 3).
- For emergency situations, you find an Emergency-Off switch on the front-panel of the
machine.
It interrupts the power supply to the power module and tooling machine.
However, the software - machine communication remains possible for fault tracing
(only type 2 and 3).
- Only experts and trained persons may handle the keyswitch since a higher risk exists in test
mode (only type 2 and 3).
Please, keep the alternative key under lock and key.
- All 230 V loads are only single-pole switched. You must assume that an interrupted load is
not necessarily voltage-free (only type 2 and 3).
- Ensure sufficient ventilation at dust or gas development that is caused by processing the
materials.
- For cooling, no flowing water may be used but only a sprinkle/chilling appliance with which
a spray causes the cooling effect (see accessories).
No drops may form themselves and flow under the clamping plate.
- Do not use spirit as coolant (danger of explosion!).
- Clean the machine regularly and remove chips and dust deposits.
To Next Page
Loading...
