Isel ICP 4030 - Occupational Safety and Operator Responsibilities

£ä
isel Ê«>VÌÊµÕ«iÌÊ*
{ i>}ÊÉÊ>Ìi>Vi
Open the hood before switching off the machine using the mains switch. After this, this is no
more possible (only type 2 and 3).
-ÜÌVÊvvÊÌiÊ>ÃÊÃÜÌVÊLivÀiÊ>ÞÊVi>}Ê>`Ê>ÞÊ>Ìi>Vi°ÊÃ]Ê«ÕÊÌi
«ÜiÀÊ«Õ}ÊÊÀ`iÀÊÌÊ«ÀiÛiÌÊ>Ê>`ÛiÀÌiÌÊÃÌ>ÀÌ}°
Clean the machine regularly with a broom or vacuum cleaner of all chips (no compressed
air). That protects the mechanics against early wear.
- With frequent machining operations and very fine chips (dusts), you should regularly
remove the cover plate of the Y-axis below the T-slot plate and remove possibly penetrated
chips and/or dusts.
- The sealing lips include a Teflon component and require no special maintenance.
- Clean the perspex windows with a non-abrasive fluid cleaner.
- The shaft guides and drive shafts are provided with a long-term lubrication ex works.
Depending on the load, you should grease the shaft guides and drive shafts approx. all
500-1000 operating hours. Use usual rolling bearing grease for that purpose.
Ex works, the shaft guides and shafts are lubricated using GP00/000F-20 sodium soap
grease according to DIN 51 502.
Please, you lubricate all 100-200 operating hours if you use oil.
At first, make a reference movement for lubricating the driving axis. Then, open the hood
and only now switch off the machine.