Need help?Do you have a question about the Isel ICP 3020 and is the answer not in the manual?
General| Number of Axes | 3 |
|---|---|
| Operating Voltage | 24 VDC |
| Type | CNC Controller |
| Control Type | Closed Loop |
| Communication Interface | RS-232 |
| Analog Outputs | 4 channels, 12-bit resolution |
| Programming Software | Isel CAM |
Defines intended use and potential misuse of the machinery.
Specifies CNC machine applications like milling, drilling, cutting, and engraving.
Lists approved materials for milling and restrictions on certain materials.
Essential safety guidelines for operating the CNC machine.
Details the machine's enclosure and safety interlock system.
Outlines operator responsibility for base machine safety measures.
Emphasizes secure workpiece clamping to prevent accidents.
Locates emergency halt switch and explains key switch usage.
Safety measures to prevent risks to persons and equipment.
Defines requirements for authorized, knowledgeable, and instructed personnel.
Guides on correctly installing the CNC machine on a stable surface.
Describes the homogeneous frame and solenoid interlock for safety.
Critical safety guidelines for assembly and operational phases.
Explains the function of each control element on the machine's front panel.
Describes the three-pin plug for spindle output and its wiring.
Guides on setting rated current, step resolution, and current reduction.
Details how to set motor current using DIP-switches 1, 2, and 3.
Details how to set step resolution using DIP-switches 5, 6, 7, and 8.
Highlights critical safety precautions for machine installation.
Guides on connecting the communication and main power supply cables.
Step-by-step guide for the first initial operation of the machine.
Details software requirements for operating in CNC mode.
Details software requirements for operating in DNC mode.
Important safety notes before performing cleaning or maintenance.
To Next Page
