ICP 3020 / ICP 4030 iMC-P Operating instruction
page 9
Please keep the replacement key switch under your personal check.
The operator has guarantee sufficient ventilation according accruement of
dust or gas, caused by the operation process of working pieces.
If the sound pressure level near the machine should be higher than 70
dB(A) the operator has to wear an applicative ear protection.
The work at and with the machine is only allowed for authorized,
knowledgeable and instructed persons. Those persons have to be informed
by a special instruction about possibly appearing endangerments
(especially residual risk).
Do not use running water for cooling but a spray-cooling system with a
spray-fog causing the cooling effect (look accessories). Drop formation and
their gathering below the mounting table must be avoided.
3.1 Occupational safety
By following the instructions at work may present a risk of persons and / or the device can
be prevented.
Not observing these instructions may cause a danger to persons and
goods by mechanical or electrical influences or the failure of the device.
Not observing the safety results in the loss of any claims.
3.2 Operators
The machine may be operated and maintained only by authorized, trained and
instructed personnel. An instructed person is who was on her teaching duties
and the possible risks for improper conduct and, where necessary trained and
instructed on the necessary safety equipment and protective measures. Such
personnel must have received an instruction about possible dangers. As a staff
can judge who is due to his technical training, knowledge and experience and
knowledge of the relevant provisions of the delegated work and identify possible
dangers. If the staff does not have the necessary knowledge, it must be trained
accordingly.
To Next Page
Loading...
Need help?
General
