To Next Page

To Previous Page

ICP 3020 / ICP 4030 iMC-P Operating instruction

Seite 3

Table of contents

1 Introduction ................................................................................................................... 5

2 Intended use and reasonably foreseeable misuse .................................................... 6

3 Safety instructions ........................................................................................................ 8

3.1 Occupational safety ...................................................................................... 9

3.2 Operators ..................................................................................................... 9

4 Delivery status from the factory (quality safety) ...................................................... 10

5 Installation and connection of the CNC machine ..................................................... 11

5.1 Dimensions and space requirement ........................................................... 11

5.2 Transport of the CNC machine ................................................................... 12

5.3 Installation of the CNC machine ................................................................. 12

5.4 Coordinate system and reference point ...................................................... 13

5.5 Tooling machine ......................................................................................... 13

5.5.1 Enclosure with safety interlock 14

6 Assembly and operation ............................................................................................ 15

6.1 Safety notes................................................................................................ 15

6.2 Overview .................................................................................................... 16

6.3 Connectors ................................................................................................. 17

6.3.1 Connectors on the back side of the machine 17

6.3.2 Control elements on front side of the machine 18

6.3.3 Stepper motor control assembly 20

6.4 Connectors of the stepper motor control .................................................... 21

6.4.1 Access to stepper motor control and their components 21

6.4.2 Connectors 22

6.5 Adjusting the stepper motor power amplifiers ............................................. 27

7 Installation and initial operation ................................................................................ 30

7.1 Safety notes................................................................................................ 30

7.2 Preparation ................................................................................................. 30

7.2.1 Connections 30

7.3 Software installation ................................................................................... 31

7.4 Operation modes ........................................................................................ 32

Isel ICP 3020 User Manual

Questions and Answers: