ICP 3020 / ICP 4030 iMC-P Operating instruction
page 40
12 Declaration of conformity for complete machinery
EC Declaration of Conformity corresponding Machinery Directive 2006/42/EU, Annex II A
The manufacturer
isel Germany AG
Bürgermeister-Ebert-Straße 40
D-36124 Eichenzell
declares hereby, that the following products
conforms to the safety and health requirements of the Machinery Directive 2006/42/EU, Annex I – including
those at the time of declaration current alterations..
The following harmonized standards have been applied:
Safety of machinery – fundamental terms, general principles of design – Part 1:
Basic terminology, methodology
Safety of machinery – fundamental terms, general principles of design – Part 2:
Technical principles
Safety of machinery – Safety distances to avoid reaching of dangerous
regions with upper and lower extremities
Safety of machinery – Minimum distances to avoid bruising of parts of the body
Safety of machinery – Guards – general requirements for the design and
construction of fixed and moveable guards
Safety of machinery – Safety related parts of control systems,
Part 1: General principles for design
Safety of machinery – Emergency-Halt – Design guidelines
Safety of machinery – Risk assessment – Part 1: Guidelines
Safety of machinery – Electrical equipment of machines,
Part 1: General requirements
Also the following EU Directives have been applied
The technical documentation for this machine was created corresponding Annex VII Part A. The
manufacturer obligates to provide the technical documentation in electronic mode on demand of authorized
governmental agency.
Representative for composition of technical documentation is: Mr. Helmut Danz
Werner Kister, Managing Board
To Next Page
Loading...
Need help?
General
