a reduction of dielectric strength or surface resistivity”.
• Pollution degree 1: No pollution or only dry, non-
conductive pollution occurs. The pollution has no
influence.
• Pollution degree 2: Normally only non-conductive
pollution occurs. Occasionally, however, a
temporary conductivity caused by condensation
must be expected.
• Pollution degree 3: Conductive pollution occurs, or
dry, non-conductive pollution occurs which
becomes conductive due to condensation which is
expected. In such conditions, equipment is
normally protected against exposure to direct
sunlight, precipitation, and full wind pressure, but
neither temperature nor humidity is controlled.
Storage
environment
• Location: Indoor
• Temperature: -10°C to 70°C
• Humidity: 0~35°C: <90%RH
>35°C: <80%RH
Disposal
Do not dispose this instrument as unsorted municipal
waste. Please use a separate collection facility or
contact the supplier from which this instrument was
purchased. Please make sure discarded electrical
waste is properly recycled to reduce environmental
impact.
To Next Page
Loading...
Need help?
General
