3
8
COMMON CLEANING METHODS
2
1
USE OF OPTIONAL ACCESSORIES
MAX
M
A
X
MAX
APPLICATIONS
Optical Stores:
Optical stores can use ultrasonic cleaners to provide valuable
services. Use ultrasonic cleaner and tap water to remove the
debris on the lenses, hidden in the rims and nose pads so the
eye wear gets professional cleaning and care.
Homes:
Children and baby items: Debris left in small holes and
crevices are difficult to clean by regular means. Bacteria and
mold can develop at these locations. Ultrasonic cleaners can
remove the debris and be combined with disinfection to
achieve true cleaning.
Eyewear, watch bands, shavers, razors and other household items: Ultrasonic cleaners
can be used to clean the debris between the rim and the lenses on eyewear, between razor
blades, and on the metal mesh of shavers to keep the blades sharp.
Jewelry Stores:
Jewelry stores can use ultrasonic cleaners to expand services.
Jewelry such as necklaces, diamond rings, rings, earrings can
be cleaned with tap water to recover shine.
Mobile Phone and Electronics Service Shops
PCB renewal: Non-operational electronics, after falling into
water, or non-operational key pads can be cleaned with
ultrasonic cleaners and pure alcohol to recover the functions.
Watch Service Shops
Precision parts cleaning: Put small parts in a beaker made of
stainless steel or glass filled with lubricant oil, then place the
beaker inside the cleaning tank and add water. Ultrasonic
waves will penetrate the beaker and act on the parts to make
them clean.
Printing Shops
Unblocking dried printer heads or ink cartridges:
Large printers and inkjet printers often have dried printer
heads or ink cartridges ports. Replacing them with new ones
is very costly. Adding acetone or special cleaning solution and
using an ultrasonic cleaner with a couple of minutes of
cleaning will remove the blockage and make them usable again.
Avoid acetone from contacting the plastic housing to prevent
corrosion. Use Indirect Cleaning explained later and a glass or
metal container for acetone.
REGULAR CLEANING
Use tap water only
Cleaning Method:
1. Put the items to be cleaned inside the basket and put the basket
inside the tank (or put the items inside the tank directly ).
2. Add water to the cleaning tank to a level between "MIN" and
"MAX" lines and above the area to be cleaned.
3. Press On/Off button to start cleaning.
Select desired
time setting by pressing Time button.
" "
Note: During cleaning, dirt will come off like smoke and the
water will become murky over time. When "smoke" stops coming,
the cleaning is basically done.
ENHANCED CLEANING
Add appropriate cleaning solutions to water
Cleaning solution can be added to enhance cleaning. Dish
detergent can be used in general.
Typical mixing ratio is one part of solution to ten parts of
water. Once it's done, run it with water only for another 90
seconds to remove residual cleaning solution.
BASKET
Use the basket to clean small and delicate items. Ensure items
not touching each other if cleaning multiple and delicate items.
WATCH STAND
Use the watch stand to keep watch body above water while
cleaning wristband.
Note: Plastic basket absorbs about 30% to 40% of ultrasonic
energy hence reduces cleaning effectiveness.
Important: For diver's watch with depth less than 50 m (150 ft),
water may get inside if watch body is submerged in the water
using an ultrasonic cleaner.
To Next Page
Loading...