Isotech TTI 7 PLUS - Page 34

Page 34 of 44
TTI-7 Iss.02 – 06/11
SYSTem:BEEPer:STATe < off/on >
Disable or enable the front-panel beeper.
SYSTem:BEEPer:STATe?
Query the state of the front-panel beeper. Returns “0” (OFF) or “1” (ON).
SYSTem:VERSion?
Query the SCPI version to which the instrument conforms. The instrument series is not compliant and returns the
message “NOT SCPI COMPLIANT”.
SYSTem:TIME < hh,mm,ss >
Sets the system calendar/clock time value. Use 24 hour clock format.
SYSTem:TIME?
Queries the system calendar/clock time value. Returns “hh,mm,ss” in 24 hour clock format.
SYSTem:DATE:FORMat < format>
Sets the system calendar/clock date format for use in date and time stamping of logged data.
<format> dd:mm:yy
mm:dd:yy
SYSTem:DATE:FORMat?
Queries the system calendar/clock date format.
Returns “DD:MM:YY” or “MM:DD:YY”
SYSTem:DATE <dd,mm,yy> or <mm,dd,yy>
Sets the system calendar/clock date value, which should be entered in accordance with the selected date format.
SYSTem:DATE?
Queries the system calendar/clock date value.
Returns “dd,mm,yy” or “mm,dd,yy”
*IDN?
Read the instrument’s identification string. This is of the form:
“<manufacturer>,<model no.>,<serial no.>,<software version>”
The serial no. field is not used.
*RST
For IEEE only, clears all pending operations, and also resets the Operation Complete Command State and Operation
Complete Query State.
*TST?
Always returns ‘0’ to indicate self-test OK.
*WAI
This command is accepted, but ignored as all commands are executed sequentially. It is provided only for
compatibility with IEEE-488.2.